Bowl Holder

thingiverse

A typical Bowl Holding Device. This is used to hold up a decorative bowl of most sizes. If you put the hooks on the top, the bowl can be be a rather large one. Instructions You need to print two of each part. The pieces are designed to be a tight fit. I printed the parts with 35% fill, 3 shells, and .2 mm layer height. You can experiment with these settings however, you will have to apply a significant amount of force to get the pieces assembled. The reason for the tight fit was to avoid using any glue. If you want to shave down the edges of the cross members a little, I would recommend using glue. I used a plastic mallet in the following way... First you want to tap each corner of the cross member into the arm. Then once both corners are able to fit, try the entire tab. Tap both cross members into the same arm then tap the other arm onto the cross members. Good Luck.