Bowl and vases with openscad source file polygon generator.

thingiverse

The entire solid generates from OpenScad file with a skin of triangles right away.\nYou can easily stretch or shrink it to get any size you want or pause at any point to get a partial print done successfully.\nThe clear and "blueberry" tall vases for instance are z-scaled to 200mm high in height precision.\nThese models have been run through meshlab already to remove duplicate vertices created by my outdated openscad script. \nIt's now possible to print them easily with any slicing program you like now.\nAll these models are low poly compared to the scripted solids that were generated later.\nThe downloads reset back to default when I updated to repaired files, however.\n\n\n\nThe Basics: Generating a Solid:\nGenerating a solid takes just seconds.\nTo turn it into a vase or bowl instead, set it up as one perimeter with the "vase" mode on and turn off any top layers for a nice, clear effect.\nNo need to worry about filling in areas since you've disabled it.\nUse three bottom layers for added strength.\nChange your nozzle size setting for better results and speed.\nThe optimal feed rate is around 25mm/sec on outer perimeters only - not on fill or inner walls though.\nFor bottom layers, however, go slow and squeeze that extra-wide track out!