Bowden tube support clamp for Tevo Tarantula

thingiverse

Bowden Tube Support Clamp for Original Tarantula Carriage. In some situations, such as high Z or short tubes, the Bowden tube tends to overflex just before the hotend. This clip attaches directly to the original carriage, providing a more tapered bend for the tube into the hotend. Easy to print and designed to fit just behind the radial fan fang (as shown). Supports the tube in any direction. Comes in two versions: v1: More rigid with a longer vertical support shaft. Use this if you bundle all cables to the Bowden tube itself. v2: Taller and wider, sufficient for the Bowden tube only. Instructions: 1) Decide if you need this (you know you do). 2) Print flat, no brim, 10% infill maximum at 0.15mm layer height. 3) Remove the filament, disconnect the PTFE tube from the feed stepper. 4) Slide the clip in (should slide smoothly). 5) Push firmly (holding the carriage) until it clicks into place. 6) Reconnect tube, reinsert filament. 7) Resume printing.