Bowden tube support clamp for Tevo Tarantula

prusaprinters

<p>Bowden tube support clamp for the original Tarantula carriage. In some circumstances (high Z or short tube), the bowden tube tends to overflex just before the hotend. This clip snaps directly on the original carriage, providing a more tapered bend for the tube into the hotend. Easy to print and designed to fit just behind the <a href="https://www.thingiverse.com/thing:2175956">radial fan fang</a> (as pictured). Supports the tube in any direction.</p> <p>Comes in two variants:</p> <p>v1: more rigid, longer vertical support shaft. Use this if you bundle all cables to the bowden tube itself.</p> <p>v2: taller, wider support shaft. Sufficient for the bowden tube only.</p> <p>Instructions:</p> <ol> <li><p>decide if you need this (you know you do)</p> </li> <li><p>print flat, no brim, 10% infill max at 0.15mm layer height</p> </li> <li><p>remove the filament, disconnect the PTFE tube from the feed stepper</p> </li> <li><p>slide the clip in (should slide smoothly)</p> </li> <li><p>push firmly (holding the carriage) until it clicks in place</p> </li> <li><p>reconnect tube, reinsert filament</p> </li> <li><p>resume printing</p> </li> </ol> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.15mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>10%</p></div> <p><strong>Notes:</strong></p> <p>Needs little-to-no infill. Just ensure to have enough shells (at least 2) to make the end clamps completely filled.</p> </p></p> Category: 3D Printer Accessories