Bowden Tube support block for Ender 3/V2 Satsana Shroud

thingiverse

I made this support block for the Satsana shoud to stop the bowden tube being moved about at the hotend.It makes sure the tube is held perpendicular to the hot end.Hopefully this will reduce the amount of stress on the retaining clip where the tube is held into the heatbreak, and in turn reduce the chance of tube moving away from the heatbreak.I have been using for a while now and have had no issues. the block is just held in place by a small cable tie using the existing Satsana cable tie holes, so no modification to the shroud is needed.Only tighten the cable tie sufficiently to hold it securely in place and not to cause a restriction in the tube.