Bowden tube fitting wrench for XYZ Da Vinci 1.0 Pro

thingiverse

This essential wrench enables you to replace the bowden tube fitting attached near the extruder motor without disassembling all the covers of your xyz printer. Simply lift the top cover, remove the bowden tube and filament, and insert the wrench (line up the notch with one of the corners) then turn left to unscrew the fitting. This wrench has been thoroughly tested with the original fitting that comes with the machine as well as uxcell fittings found on amazon: https://www.amazon.com/dp/B009ITFXDI/ There are three wrenches available, an all-in-one that requires no additional tools, a bit that can be used with a standard bit driver, and a socket that can be used with a standard 3/8" socket wrench. The parts were successfully printed on a XYZ Pro in 0.5mm, 1mm, and 2mm using Simplify3D for slicing. I highly recommend using 1mm or better due to the chamfered edges at the opening. It's also recommended to print slowly especially near the opening due to the extremely thin walls. Supports are only necessary for the bit version (depending on orientation). The parts may require sanding or finishing, at least around the exterior tube especially if there are blobs or strings. Print Settings Printer: Da Vinci 1.0 Pro Rafts: Doesn't Matter Supports: No Resolution: 1mm Infill: 15% Notes: Supports are only necessary for the bit version (depending on orientation). Post-Printing The parts may require sanding or finishing, at least around the exterior tube especially if there are blobs or strings.