Bowden Hotend Clamp for Vulcanus V1

thingiverse

I saw no point in using a direct drive extruder on the Vulcanus V1, especially the one that was suggested, since that extruder probably wouldn't work with flexible filaments, plus bowden extruders are faster. So I created this hotend clamp to allow you to use a bowden extruder - with a hotend designed for use with a bowden extruder. This clamp prevents the bowden tube from slipping out of the hotend, provided your hotend has a bowden tube fitting built into it like mine (E3D V6), and also prevents the bowden tube from getting bent too much near the hotend, which can sometimes cause under-extrusion. To install this clamp, you will need two M3x20mm screws, two M3 hex nuts, and the "CoreXY_X-Carriage" part designed by Vulcaman for his Vulcanus V1 printer. I designed this to fit the E3D V6 hotend, but I can't guarantee it will fit any of its clones.