Bowden clips CR-X Pre Extruder

thingiverse

This is a clip that securely fits onto the default housing of the CRx left side, perfectly aligning the bowden pipe with the extrude unit. A couple of other clips I designed online for the bowdens were too tight for my tubes, which measured 4.0mm in diameter. So if yours are slightly smaller, you may need to scale down the tube retainer a bit. I left it as loose as possible to prevent compressing the tube at all. V1.1 Iteration Updated with an opening on the side, because the tube tends to lift up generally. Hole size increased to 4.1mm for use with 4mm OD Bowden Tube Grib width set at 2.7mm V1.2 Added RHD piece. This is a funky diagonal design as it has to dodge the Z lead screw attachment. It works well, though.