Bow // Limps Quiver V2

thingiverse

I'm excited to share with you the V2 of my simple Bow Quiver. All parts except "unten.stl" are printed using Filaflex, which is a great material for this project. The "unten.stl" part was printed with ABS, but you can also use PLA if you prefer. To ensure a strong quiver, I recommend printing all the Filaflex parts with at least 50% infill. In addition to the printed parts, you'll need two pieces of 7mm pipe to attach the quiver to your bow's limbs. A 6mm screw and nut are also required for this attachment. The length of the screw will depend on the width of your bow's limbs. I used a piece of a Goldtip Warrior 600 Arrow to create the quiver, which works perfectly. To assemble the quiver, first glue the pipe into "kocher." Then, use "schutz" to secure it in place. Next, attach the quiver to the correct position using some strong rubber bands. I used a piece of bicycle tube for this purpose. Finally, you can use "stopfen" to close the pipe on the outside. To add extra protection and stability to your quiver, fill it with foam. Note: If you're fluent in German, you might notice that I made a mistake when naming the "unten.stl" part. It's actually the upper part of the quiver! Print Settings: Printer Brand: Wanhao Printer: Wanhao Duplicator i3 Plus Rafts: Doesn't Matter Supports: No Resolution: 0.1 - 0.3 Infill: Filaflex parts at least 50%. ABS or PLA parts 25%