Boulders for Gloomhaven Maghex

thingiverse

Simply, it's a remix of Robagon's original boulders with a hole in the bottom for a single 6x3mm magnet. This is useful for Maghex tiles to have your terrain stick to the board and not get knocked around accidentally. You can use the 6x3 Magnets on 3x3 Maghex tiles. That's actually what I'm doing, but the larger magnet helps it stick better and it has enough room for it. Like Robagon's original they're all flat topped so minis can stand on top of them for climbing. The Hole is ever so slightly chamfered to prevent elephant's foot causing inserting a magnet to be tricky. I didn't need to print with supports for the magnet hole. It is a friction fit however, so you shouldn't need glue. I printed at 0.2mm layer height with a 0.4mm nozzle, a very standard layout. However, only having 2 shells did make some ever so slight seams. Robagon's original reccommends 0.1mm layer height, so either try that or boost the wall count up to 3 and you should be good. When I say slight, I mean none at all on boulder 1, somewhat noticable on boulder 2, and a very tiny pinhole that you could miss if you're not looking for it on boulder 3. UPDATE 1: Turns out that Flat_1 happens to have a small batch on the bottom face of the boulder that isn't perfectly flat when scaling the rocks up or printing at a lower resolution than .2. The original rock has this same little patch too, but I never noticed it on the original file or the remix because I printed at a higher resolution. I went ahead and updated it so the Flat_1 boulder sits perfectly flat even at a more precise resolution or larger size. I also made it a remix of the original Maghex tiles as well so you'd find this listing if looking at remixes so it'd be easier for people to find terrain to print if they're new to the system and looking at its variants.