Bottom plate for Ardunio Mega 2560 Ramps 1.4 Box

thingiverse

Added tabs to attach to Wilson 2 printer, shouldn't be too hard to customize for other operations. Print Settings Printer Brand: LulzBot Printer: TAZ 5 Rafts: No Supports: No Resolution: .18 Infill: 20% Notes: Used a .35 Nozzle on this print, using Cura for Luzlbot Taz 5 predefined settings of ABS High Quality. Post-Printing Trim the edges should there be any oozing from the base layer squish. How I Designed This Used 123D, pulled in the base remix of http://www.thingiverse.com/thing:1452085 by coreygeorge. Measured the dimensions of the plate, added two 20mmx20mm tabs with a 5.4mm hole to accommodate a 5mm screw, the third tab on the side was of similar methodology, adding a slot rather than a standard hole, along with a little extra base to use a washer when attaching. Side Notes Wilson II I am building a https://github.com/mjrice/Wilson2 by MJRice. Currently I'm purchasing components as I have the funds, so the build is going slow. I have been printing my plastic pieces at the FabLab located here where I live. If you have suggestions or comments on my endeavors please feel free to comment. Would love advice, and suggestions... UPDATE 1/21/18 As it is, it will get in the way of the Z-Axis. After doing a test assembly I realize this will NOT fit on the Wilson II, at least not as I intended. I have yet to finish my build as circumstances have changed. I may do some tweeking to this model to get it to work.