Bottle pet drinker

thingiverse

Remixed to eliminate bridge sections, substituting empty spaces instead. Dimensional adjustments made to fit a standard 1.75L Coke bottle lid. The lid opening is slightly oversized since my printer prints 0.3mm under the actual size. Dimensions are: 50mm in height 100mm in diameter Designed to fit a bottle top with a 30mm diameter Print Settings Printer: CTC Rafts: No Supports: No Resolution: 0.2mm Infill: 20% Notes: Sliced using Cura 2.4, 0.2mm layer height, 0.4mm infill height, 3 walls, and 4 solid top and bottom layers Post-Printing Coating I applied an acrylic clear coat to ensure the part remains watertight since it will be used outdoors. Two to three thin layers were applied, 15 minutes apart. A 5mm hole was drilled into the bottle lid. Initially, I used a hot glue gun but found this method hit-or-miss. I then switched to using two-part epoxy instead, which achieves the desired result. Depending on the material the bottle is made of, you will likely need the support rings. Without them on a 1.75L "Coke" bottle, it collapses inward and water flow ceases.