Botgrinder Grinderino Monster Feet arm bumpers and skids (snap on)

thingiverse

I liked the monster feet but did not want to use zip ties and did not want the screws to squish the TPU so I combined it with the socks and then spent some time fitting it so they could snap on. These are shorter so there is no motor protection. You need to squeeze an push the nub into the hole for a secure fit. It wraps around the top a little but there is enough clearance for the motors.These can be installed before or after you install the motors. You can even remove your motors after these are on without having to take them off.It only raises the bottom barely, so I made another model wth 5mm "skids" on the bottom. I don't know how to smooth the sides in tinkercad so I'm sure someone could clean this up, but they print fine with no supports.