Bosch Pick and Click 50mm bit holder

thingiverse

These fit Bosch Pick and Click Case M (2608522362) & L (2608522363). The difference is not immediately apparent but the L allows clips on both sides of the clamshell and the M only on one. I wanted to make up some strips for 50mm bit but didn't want to buy £12+ of bits I didn't need just to get the strip. Longer bits such as 90mm drivers also fit these strips - it's just the 25m bits that don't. These don't have the retaining clips as I found that they just snapped of at a layer line. This may have improved if I'd printed it on edge but then it would need supports for the end fittings...and so far all the bits stay put so I think that simple is preferable. If you're using Fusion, the clearance for the bit is configurable as a parameter. This defaults to 0.05mm per side and that seems to fit all my bits quite nicely when I printed in PETG. PLA should also work fine.