Bosch oven hanger

prusaprinters

Our oven had these hangers that we got with it, these hangers were stuck in one position so that when you opened the oven up, stuff would fall off from them.This design is designed to fit the bosch oven (idk the exact model). I have no idea if there are other ovens that are compatible with this.The model is split into 3 parts: 1) This is the part that will be placed on the oven handle. It's dimensions are set exactly so that it doesn't fall of but still is easy to put on the oven.2a) This is the part which is connected to the first part by a piece of filament which will also serve as the axis on which it will rotate.2b) This serves as the hook where you will put your kitchen tools.AssemblyThe assembly is very simple and all you need to have is a piece of 1,75mm filament that fits inside the hole in the part 2a and you also need a bit of super glue.After printing take the 2a part and with a bit of superglue on the flat piece sticking out of it insert it into the 2b part's hole. Make sure you place it in the correct orientation (The hook must face away from the hole where you place the filament). After that is done all you have to do is place the 2a+2b parts between the holes of part 1 and insert the filament through all of the holes. Then you can just place it on the oven handle and it's ready to use.Printing instructionsPrint all parts at 0.2mm layer height or lower, at 0.3mm the holes could be too small. Other than that you can do pretty much anything with the settings.