Bosch GSR 12V FC FlexiClick auto-feed screw gun attachment

thingiverse

Adapter for auto-feed screw gun attachment. Assembly: - remove the two screws holding the guide - pull out the plastic part nomaly clamping on the drill - push in the printed part instead - screw the guide back on Bonus: Attach the adapter sideways to still get some light on the workspace. I only testet the adapter with a 143mm bit, like the one included with the screw gun attachment. Other versions are calculated based on that, feel free to give feedback if they work or need to be adjusted. Support included, no extra support needed. Remove the outer ring arround the GSR fixture after printing. Edit 06.09.2023: I added a version for Bosch Bits (2 608 522 068) with restrainer. You may need a little support in the middle to print it and/or can put a M6x12mm washer in. Note: Bit is labeled as 145mm or 146mm on the box, measured length on mine is 146,5mm Edit 08.09.2023: Added a "V2", where the attachment has a slight offset to the fixture, so the bit runs straight trough.