Boroscope camera mount for SeeMeCNC Orion / Rostock

thingiverse

I've been struggling with getting a solid angle from my webcam for monitoring prints, so I decided to buy a budget boro/endoscope from Amazon. I built it to attach to my E3D extruder mount, and your results may vary since it's not the factory aluminum hot end mount. Rev 1a: I added a cut out for a zip tie to hold the camera instead of a rubber band. Rev 1b: I added a locating notch to the washer and the mount to reduce spinning. Rev 2: I added a second arm to eliminate any remaining spinning. It should work with aluminum spacers on the hot end once the inside diameter is changed, and the camera is still secured with zip ties to the camera mount. Print Settings: Printer Brand: SeeMeCNC Printer: ORION Delta 3D Printer Notes: You may need to scale up to get your camera to fit. I used a rubber band to secure my camera to the mount, which has an OD of 6mm. To get the best results, orient the mount with the flat side facing down. Post-Printing: View from the camera using Yawcam / streaming