Borg80mm Vixen dovetail bar 15mm spacer

thingiverse

# Borg 80mm Rings to Vixen dovetail bar 15mm spacer Our physics department had a problem with this scope bumping into stuff because it was too low to the dovetail bar, creating chaos everywhere. I quickly made this spacer that lifts the scope 15mm off the ground, instantly solving the problem. I am still concerned about the PLA's potential deformation over time, but since the scope is hopefully never hot, the risk is minimized. If the spacer were to fail, the bolts would still hold the scope to the bar, albeit loosely. # Printing Printer: Makerbot Replicator+ The part displays horizontally on its side, so it needs to be flipped 90 degrees onto its bottom before printing can begin. - Print settings are set at 2 shells for maximum strength. - A fill of 20% is optimal for a sturdy print. - .2mm layer height ensures precise details. - .4mm infill layer height provides excellent structural support. - Black Makerbot PLA is the chosen material.