Bora Orbiter 5015

thingiverse

This is an update of Leo's Bora fan mount for the 5015 that includes an Orbiter extruder mount. All of the fan ducts from the original Bora should work fine. I have tested this mount for several months with my Orbiter and printed at speeds up to 120mm (using Klipper) without any issues. This is a relatively fast print - Cura predicts 3:32 for .2mm layer height, 4 walls and 30% infill at max speed of 80mm/s. You will also need the cooling duct that clips onto the end of the 5015 fan and the duct from the 4010 to the hotend's heatsink. Leo's original duct was for the Winsinn fans. I ended up with Sunon fans, and had to modify the original duct to fit - that is the "5015 cooling duct Sunon" STL. The 5015 duct adds about 40 minutes to the print time. The duct for the 4010 heatsink cooler should work as-is, and adds another 40 minutes to the printing time. All in, it will take about 5 hours to print them all together and have a working Orbiter direct drive setup with a 5015 fan. See the original Bora project for the BLTouch bracket. Need 2 M3 nuts for mounting the Orbiter, one nut is press fit from below the mount, the other slides into a slot from the side facing the carriage.