Boostinjdm Whoop Canopy

thingiverse

These are whoop canopies I came up with. I designed them around the Mobula 6, but they should fit most whoops. They are camera specific. They aren't lightweight, but I don't believe they are much, if any, heavier than the stock canopy. My scale isn't accurate enough to tell a difference. I wanted something sleek, durable, and jello free. The THF version is for the Tinyhawk Freestyle board cam and will allow for a dipole antenna out the back. The RX antenna hole is sized for a typical xm, xm+, Rxsr, etc. antenna. The THF cam plugs right into the Mob6, but you have to swap two of the wires in the plug first. Cam angle is a fixed 20 degrees if I remember correctly. Might be 25. The RCN3 version fits the RunCam Nano 3 that comes stock on the Mob6. The RX antenna hole fits the stock Mob6 antenna. The nub at the back is for the end of the VTX antenna. This nub can be cut off to make a hole for other types of antennas if needed. It was designed around a 25 degree camera angle. This just barely shows the whoops in the corners of the view. You can squeeze a little more or less angle out of it, but not much. ETA. I finally got a good scale. Factory mobula 6 canopy weighs 0.7 grams plus whatever the foam weighs. My RCN3 canopy weighs 1.3 grams after trimming. So half a gram or so is the cost of durability and no jello. I have both of these canopies in use on my own whoops. Yes, they are Mob6 parts in Beta frames. I'm open to critique and suggestions, but don't get offended if I ignore them. I can only do so much and prefer to stick to designs I would use myself. You're on your own for odd stuff I have no interest in. I'm new to Thingiverse and don't know how the whole "Tips" thing works, but any tips would be greatly appreciated and rolled right back into printing supplies or parts to design more things around.