Boostinjdm TwigXL Canopy and other TPU parts

thingiverse

TwigXL parts I designed. The canopies should fit other Twig models as well. The canopies aren't light, but they are durable and stylish :) . The full featured version is about 6.5 grams more than the factory canopy. There are mounting points for the BetaFPV A01 Vtx and recesses in the legs for capturing nuts. The file names should be pretty easy to understand. "Canopy" is plain. "Fin" includes the fin. "BWR" is battery wire retention. It's a tail to zip tie the lead to for FC with center-rear battery pads. 6/4/2021 First time out racing and managed to blow up my camera centering a post at speed. Replacement Ratel 2 is lighter and slightly smaller. So the Canopy got some slight tweaks made. Same weight, same look, hard to tell the difference from a couple feet away, but the new versions fit the Ratel 2 and give a little more clearance between the FC and VTX for sneaking in a capacitor or RX. I have both. 6/18/21 My stock VTX failed shortly after replacing the camera. The new BetaFPV A01 comes with a ufl and dipole. So the canopy got redesigned yet again. I have flown this new version and despite being a dipole, it performs very well. Well enough I have no plans to change over to RHCP. I do this stuff for fun and am willing to foot the bill, but the cost of parts and materials start to add up. If you like and use my designs, any tips, no matter how small, would be greatly appreciated.