Bookstand ; Leaning against the wall Type

thingiverse

This is a basic Bookstand ; a type leaning against the wall. So, we require a wall to lean on, such as a reading room desk or a monitor. It's simple but can keep books stable with two paper presser feet. The additional presser foot end for a thin book is optional. You need m3x25 cap screws and hexagonal nuts (2 pieces) or pointed screws are also fine. To prevent slipping, I used glue on the floor. You may attach a rubber or non-slip pad to the floor. Place the stand over the wet surface before the hot melt glue dries, and the plane becomes flat. I printed it at 2mm shell thickness and 0% filling with PLA.