Boo, the small cellphone trepod key ring

thingiverse

Hey everyone, I'm the creator of Boo, an amazing trepod designed to safeguard our precious belongings!!! So, many people have been asking me for the STL file, and here it is. I must admit that I was hesitant to share this STL because it requires some adjustments and precise calibration of your extruder. The entire design relies on press-fit components, but be sure to clean the holes gently with a drill bit to avoid any damage. For the hinge, I simply used a nail. Only one part needs to be glued - the center pin that locks the legs in place. If your bridge is weak, don't worry; I've included an extra, shorter pin for added support. Additionally, you can opt for non-retractable pins if you prefer that design choice. In my opinion, this little trepod is a formidable challenge for any 3D printer: ) Have fun printing, everyone!!!