BONG ADAPTER

cults3d

An adapter for bongs/rigs. Allows you to use 16mm pieces in 14mm circumstances. I am using it on my custom bong found here. Sliced using Cura 5.01 Printed mine in ABS at .3mm layer height @65mm/s with no enclosure on a Kingroon KP3S… So you should have no excuses or trouble printing with PLA at any layer height ≤.3mm. 2 walls. 99% concentric infill. Print however you like, but I did mine like a cone with the big hole on the print bed. Recommend a brim, although I didn't use one. I did inside before outside walls, but I think it might not matter. You should end up with a ~25 minute print time.