Bondtech LGX Lite adapter for Flsun V400

thingiverse

Printed with eSun ePA-CF, very solid stuff. ABS won't work since it tends to expand. I'd go for PETG/PLA if something not out of the ordinary. Needs to be very solid so 100% infill. Installation: 1. Drive a M3 screw through all the holes beforehand to make the threads and easier installation later on. 2. Screw the LGX Lite to the adapter with headless M3 hex screws from underneath. Don't tighten too much as the LGX will fail. 3. The original filament guide needs to flattened a bit. File the "teeth" off. 4. Plug the adapter on top of the original heatsink. 5. Check that the hole in the LGX is perfectly aligned with the heatsink from below. 6. Tighten the adapter to the effector body with M3 screws and big enough spacers. (I cut this plate from aluminum shown in the picture. 7. Check with a piece of filament that it moves freely though the extruder and filament guide. Adjust if not. The attached config section has the ATC sensor type for the CHC Pro and the original commented out. You might have to do the klipper extrusion test to get things exact. The config section is from https://github.com/Guilouz