Bondtech DDX Single 5015 blower cooler

thingiverse

Print however you want it. No supports necessary. This print is a redesign of my original dual-5015 blower design. The aim of this is to fix these issues: 1. 2x 5015 blowers is way overpowered. They ran under 50% most of the time. 100% gave rough finishes to parts. 2. It was huge and hard to remove 3. Required extra wiring work to set up fans in parallel or series 4. I had no room to mount a BL Touch or other probes. Changes from the double-cooler: 1. Redesigned and slimmed-down ducting, especially on the side opposite the fan 2. Only uses two screws to connect to the bondtech DDX 3. Larger clearance cut in for the large size of the Slice Copperhead hot block. 4. Beefed up the mounting tab on the front so it doesn't fall apart. 5. Tons of clearance on the left side for mounting other components. 6. Alternate design for Noctua fans which are 20mm thick 7. Added BLTouch mount (bolts into the BondTech extruder though, may not be a good thing)