Bondtech DDX Ender 3 Wiring Adapter

thingiverse

For those that have the bondtech DDX on your Ender 3 but don't want the wiring harness to go up and in front. This adapter set will allow you to route your wiring loom to the back like the original. This was printed in PLA using 35% Gyroid infill for added strength. For best results print the Extruder Bracket Wire Tie Down in it's STL orientation WITHOUT support. If your bed is sticky enough a raft will not be required The DDX Cable Reroute, also print in it's STL orientation WITH supports. BUT, block supports towards the top where the wire loom lays to prevent support material in the zip tie tunnel. This was designed using the original Ender 3 Fusion 360 plans from the official Creality github and fit my Ender 3 V2 perfectly.