Bond Scuba Kick Mod VUK Surrounds

thingiverse

This is part of the Bond Scuba Kick Mod for the Stern Pinball 007 James Bondhttps://pinside.com/pinball/forum/topic/007-bond-scuba-kick-mod-taking-orders#post-7802735This add on resolves some issues experienced during multiball where 2 balls in the VUK caused misfires. If you wish to print his and install:1) undo the left / bottom wireform 11-32 nut, the screw and the small 5-16 nut on the top of the metal plate. You can leave the top wireform nut alone (the one with the small Alan key bolt)2) lift the plate off3) remove the left post connecting the VUK bracket.4) replace the left post with the new 3D print using the same screw that was in the existing left post. Don’t tighten all the way5) place the long screw in the right red post and place it in the right VUK screw hole so that you have the resting place for the new 3D print in the correct spot.6) now tighten the left post screw by hand7) remove the right post and screw and now reinstall the scuba kick plate and wireform. Multiball problems are now gone, enjoy!