Bolt for Jetson TK1 | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Instructions Using the following settings: nut_height: Set to 6 mm Nut thread angle set at 45 degrees Non-threaded shaft diameter is 1 mm Nut resolution adjusted to 0.5 mm Thread length is now 55 mm Outer diameter of threaded nut section is 9 mm Non-threaded portion of the nut measures 2 mm in depth Customizer's recommended default for overall print quality is set to 0.5 mm Head of bolt diameter is fixed at 6 mm Hole for drive type was not provided so it is left blank Threads on this particular model will advance by increments of 2 degrees Part classification: a fastener type Outer diameter measures 14 mm, with a thickness of 2 mm Slots are cut into nut 2 mm deep This custom bolt's dimensions were established to facilitate socket wrench usage Inner ring or center hole has an inner diameter of 8 mm Type of nut used here is standard type Model has been faceted in a symmetrical manner using six equal sized facets A total exclusion was implemented for the inclusion of texture