Boitier ventilé v3 RAMPS Arduino LCD12864 / LCD12864 Arduino RAMPS case with fan v3

thingiverse

The provided text is an instruction manual for assembling a 3D printed case for a DIY 3D printer. The manual provides step-by-step instructions on how to assemble the case and install various components such as fans, cables, and the LCD screen. Here are the key points from the manual: **Preparation** 1. Print and clean four parts of the case. 2. Remove printing material supports from the side panel (SD card slot). 3. Remove printing material support from the LCD frame (button passage). **Assembly** 1. Optional: fasten 25x25x10 fans with M2.5x16 screws. 2. Slide the 40x40x10 fan into its housing and close the trapdoor. 3. Mount the 2.1x5.5 female power connector. 4. Connect LCD cables to the RAMPS board only. 5. Slide Arduino and RAMPS cards into the case (previously wired). 6. Clamp cables using a plastic tie. 7. Connect fan and power connector to the power terminal block. 8. Place the LCD screen in its frame. 9. Fix the LCD frame with screws (M3x20 at top, M3x25 at bottom). 10. Install the side cover with screws (three M3x20, one M3x25). **Additional Notes** * The manual assumes that the reader has already printed and cleaned the four parts of the case. * Some steps may require additional tools or materials not mentioned in the manual. * The manual uses photos from the v2 assembly to illustrate some steps. Overall, the manual provides clear instructions for assembling a 3D printed case for a DIY 3D printer.