Bobble Letterboard

prusaprinters

Let your message bounce while printing.. (or use it somewhere else)Plan on mounting my one to the bed, just at the front out of reach of the print head, so it sways nicely to the rhythm of the printer. I used Agustin "Flowalistik" Arroyo letterboard to create this one.It's best to use his letters for the board (scaled to 50%).Initialy scaled the board to 50%, a nice size for a bobble"head". Later I reduced the scale of the board slightly to 49% so that the letters were firmly attached. Depending on the accuracy of your printer, it may be necessary to adjust the scale factor of the letters slightly (e.g. 51-52%). Make a few test prints of some letters before you print all the letters. Make sure you have a tight fit, otherwise the letters will fly around....The design of the springs is a bit different, just because I liked it.Small warning: the letters are very thin and when loosened from the printer bed after printing they can fly in all directions...