Boat Bimini for monster tower

thingiverse

Buy electrical conduit to fit your desired width. Also buy 90 degree elbows. use conduit connectors to join them. I used some machine bolts to fit the holes and attach to clamps any nut and bolt will work for hinges. 1 clamp latch, 1 clamp front, 2 clamp middle 1 clamp with attahcment point for each side. 100% infill for every piece. The conduit connectors must be printed lying down so they print on the long way, if not they will break (learned this the hard way. Each side of the poles must be attached to boat as well with thin rope front and back. This also allows you to put the tilt you need. I just used a tarp I had lying around for initial testing. Sowed the ends so that the conduit would fit thru. works well and you can adjust to fit your boat as you wish. I printed in PETG