Board game organizer hex tiles

thingiverse

This is a set of hex tile organizers I designed for use with board games. The dice rolling tray is different than the single compartment tray in that it does not have a radius at the bottom, hopefully keeping the dice in better. Holes are designed to accept 6mm x 1.5mm magnets, I used superglue to hold them in but they do press fit fairly well depending on printer tolerances. Every other hole is designed to accept a hard drive screw if you want to cut down on the amount of magnets. Make sure you alternate the poles of the magnets so that the tiles can lock together properly, and make sure you do them all the same so that they will all face the same way (only really important for the card holder). This is listed as NON COMMERCIAL, you may print these for personal use ONLY!