BN-880 mount for CRUX35 - Remix

thingiverse

My first remix! Made in Tinkercad. Wanted a simple mounting option to put a BN-880 GPS/Compass on a Crux35. Every available model was for smaller GPS units. It has clearance for a Runcam Thump Pro in its stock mount. Secure with a zip tie. Adding a bit of foam double sided tape or foam rubber is optional. After 12 Betas (5 of which were printed) version 3 is available. Version 3 change log: -Now deigned to be printed with PLA. No plans for a TPU version now. left v2 files as it might work for TPU. -just over 2 grams and designed to shear off in the case of a large crash. Almost half the weight of v2! -Now allows for ~30 degrees of tilt for a Thumb Pro with its stock mount. -Made one side of the top sloped to make putting on the GPS cover easier. ****If you have problems with the overhang this requires please print the "LESSOVERHANG" version. You really need decent cooling fans/ducts for the normal version. "LESSOVERHANG" version is technically stronger and easier to print; however it weighs slightly more and its slightly harder to put the GPS cover on/take it off. "Pick you're poison" situation. The picture with supports is an example of how the supports should look. Get yours to look similar or results may vary. I haven't had chance to make sure it gets a good GPS link while so close to the camera (Lots of snow at the moment). If you give it a try yourself please let me know how it goes. Please do not depend or even try return to home until you have insured that GPS works well in your use-case. The CRUX35 mounting part is from mmh2022 and the BN-880 GPS mount is from SECOUM. You will also need to print the cover from the original GPS mount. That file can be found on the [original models page](https://www.thingiverse.com/thing:3635443) made by SECOUM. You will need the BN880_SUP.stl file.