BMG + E3D v6 Direct for Tronxy X5S

thingiverse

This is a remix of "The Tank" by Greg191134 for the Tronxy X5S, completely redesigned to sit atop the rear X-gantry plate. The front plate currently in place must be relocated to the back, allowing you to keep the cable chain out of the way. Essentially, you will need to reverse your entire X-gantry setup. Additional edits include removing excess holes, trimming the fan shroud to fit a standard 10mm thick fan (although a 20mm thick fan can still be used), and adding extra height to clear the upper x-axis rollers. A small space has also been created for the push fitting and clip on the E3D direct heatsinks. All of Greg191134's original fan shrouds and additional parts remain compatible with this mod. Note: Some variations exist in X5S gantry plates, so ensure your specific configuration is compatible before attempting to use this modification. To assemble: Step 1: Remove your hotend, fan shroud, and the back plate of your x-axis. Take out the x-axis from the printer, remove the upper bearings and bolts, while leaving the lower bearing intact. Step 2: Insert the bolts from the upper bearings through their corresponding holes in the Base piece. Slide the Rear metal plate from your x-axis onto these bolts, ensuring it fits flush with the Base piece. Step 3: Reassemble your x-axis. Step 4: Follow Greg191134's instructions to assemble the rest of the BMG mount.