BLV mgn Cube Xtruder Wire Tube Holder - Direct Drive

thingiverse

The 5/8 inch tube was too small for all the wires required for the direct drive system. So, I added a second tube to accommodate the Hot End Heater and Thermal-couple. You'll need to print two xtruder tubes and one left clip along with one right clip. I also included the Tube clip to hold the tubes in place; I used seven in my photos. It has a hole in the middle for a ptfe tube guide. I chose PETG for the Xtruder Tubes, as they proved too fragile when made from PLA. The other components are printed with PLA. They attach to the side openings of the motor/extruder mount for the direct drive system. The clips are tapered and designed to slide onto the tubes from the bottom.