Bltouch adapter for Tronxy X5SA

thingiverse

I upgraded my controller from a Tronxy one to a Duet WIFI. The top where the Bltouch attaches has been offset to clear the X axis limit switch if needed. I installed it on the side where the inductive probe was mounted, so there's no need to modify or print a new cover. When installing, I leave the Bltouch off and snug up the front screw just enough to make it difficult to move. The other screw is loose enough to slide it up and down as needed. Then I install the Bltouch and hook it up according to my needs (it depends on whether I'm using Duet, Klipper, or Marlin). It won't work with the board that comes installed in the Tronxy X5sa. I set up the offset per the Bltouch pdf and now I'm good to go!