BLTouch/3DTouch Mount for Folgertech FT5 R2

thingiverse

This is a mount designed specifically for use with BLTouch and 3DTouch sensors on Folgertech FT5 R2 printers featuring stock extruders and X carriages. To utilize this mount, attach the BLTouch or 3D Touch to the "3DTouch Bracket.stl" part first, then secure that part to the "Extruder Carriage Bracket.stl" part using a 20mm M3 screw and an M3 nut. The M3 nut should be inserted into the channel located in the middle of the 3DTouch Bracket part. This assembly will replace the bottom section of your X carriage as shown in the image. Required Components: 1x BLTouch or 3DTouch sensor with hardware 1x 20mm M3 screw 1x M3 nut For firmware calibration, use the following offsets: X offset: 41mm Y offset: -38mm Z offset: -1.14mm (Note: Z offset may be slightly inaccurate)