Block and Tackle - Pulleys

thingiverse

Revamped instructions for the Block and Tackle - Pulleys by SteveWall are here! Notice that a few files were missing, so I've uploaded them. Create both versions of the pulley as per the design, with an alternative using a male/female assembly instead of wooden dowels. For added convenience, use a single 3mm x 22 cap screw in the center to fasten the parts together. To ensure smooth operation, be cautious not to over-tighten the screw. Instead, utilize two nuts for a looser fit without compromising stability. Finally, remember to manufacture two half-sheaves for each section of the block and tackle.