Blob Test Tower 61mm

thingiverse

I created this with 3 round corners (2 x 5mm fillet, 1 x 2mm fillet) and 1 sharp corner. The wall is 1.5mm thick. It is 61mm tall. The first 1mm is for me to experiment with the first layer setting, the subsequent 60mm for the blob test. Usually blobs will appear when: 1) The wall perimeter is only made up of one outline, or when its width is less than four extrusion widths. 2) When it starts and stops at a round corner. Make use of S3D's ability to add processes and print each setting at 5 to 10mm height with the different settings you want to test. I recommend starting with non-starvation method first: Retraction Length Retraction Speed Wipe Distance Retraction Vertical Lift Then followed by "starvation" method: Extra Restart Distance Coasting