Blinds rod end part

thingiverse

I snapped my blinds apart. I put my blinds back together again. This piece fits perfectly into the 1/8" hole where the plastic part that connected to the turning mechanism broke away. I simply super glued this broken part back in place. If it breaks once more, I can just cut it off and glue a new one right on. This file will produce two end pieces. Printing two at a time will result in much higher print quality due to its tiny size. It takes approximately twelve minutes total, so no problem whatsoever. I printed at .20mm layer height, 4 perimeters, tops, and bottoms. No support is required. Print as shown in the file itself.