Blade550 landing gear adaptor

thingiverse

I encountered a crash with my Blade550 that resulted in broken landing gear and severely damaged mounting components. Since an original replacement part was not available, I opted to utilize a T-REX landing gear instead. However, direct installation proved impossible. To compensate for this issue, I fabricated adapter parts. The forward section of the adapters relies on existing holes, whereas the rear section necessitates drilling new ones. Union nuts were inserted into the adapters and secured with M3 bolts. Additionally, M3 screws were used to mount the landing gear. The adapters are categorized as follows: Part 1 represents the forward part with sharp edges; Part 1a denotes a revised version of the forward part featuring rounded edges; and Part 2b refers to the rear part with rounded edges.