Blade Disk Replacement for Gardena Robotic Mower

thingiverse

Replacing the cutting disc on your Gardena R160 robot mower is a relatively straightforward process that you can do yourself to keep your Husqvarna Automower running efficiently. This task requires some basic tools, including an Allen wrench and possibly a screwdriver, depending on the model of your mower. To start, locate the cutting disc housing by looking at the bottom of your Gardena R160 or Husqvarna Automower. It's usually attached with screws that you'll need to remove using an Allen wrench. Be careful not to strip the screws, as this can make it more difficult to replace them. Once you've removed the screws, lift the cutting disc housing up and set it aside. You should now see the old cutting disc, which is held in place by a retaining ring. To remove the retaining ring, use your Allen wrench to loosen its grip on the disc. This may require some force, so be careful not to strip the threads. With the retaining ring removed, you can pull the old cutting disc out of the housing and discard it. Take this opportunity to inspect the area for any debris or obstructions that may have accumulated over time. Clean out any dirt or grass clippings that are stuck in the housing. Now it's time to install your new cutting disc. Place it into the housing, making sure it's properly seated and aligned with the retaining ring. Put the retaining ring back in place and use your Allen wrench to tighten its grip on the disc. Make sure it's snug but not overtightened, as this can damage the threads. Replace the cutting disc housing by lowering it back down into position and securing it with the screws you removed earlier. Tighten the screws firmly to ensure a secure fit. Your Gardena R160 or Husqvarna Automower is now ready to cut your lawn efficiently again. Make sure to dispose of the old cutting disc responsibly and consider storing the new one in a safe place for future reference.