Blade 230s Landing Gear
thingiverse
This landing gear for the Blade 230s helicopter is angled at 2 degrees to make the tail sit about an inch higher than the stock landing gear. You'll need to print 2 "Brackets" and 2 "Skids". Print the brackets on their sides and use supports touching build plate only. Remove the stock landing gear and reuse the screws to mount the two brackets. Do not over tighten the screws. Then use extra screws to attached the skids to the brackets. It's recommended to use thick CA glue and Bob Smith Industries "Insta-set" to glue the skids to the brackets for additional strength.
With this file you will be able to print Blade 230s Landing Gear with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Blade 230s Landing Gear.