Blade 130 S Tail rotor

thingiverse

Again, a cheap part that they wanted to sell too expensive for me. That’s why I designed a propeller with a precise profile and good efficiency. In my experience, it’s a little better than the factory, but certainly not worse. I designed the shaft hole size to be larger because it was good for me after printing. If anyone has a problem with this, let me know and I'll upload a narrower one. I printed from a high-strength UV resin material with a Wanhao D7 SLA printer. The supports were cut off with a scalpel during the isopropyl alcohol wash. It is also possible to print with an FDM printer, but I recommend it only for advanced users. I haven't tested it, but with a 0.2mm nozzle in 0.02mm layers, at a speed of 20mm / sec, with good cooling, it's possible to get good results.