Black Widow Perk Pin-Fallout 4

thingiverse

This is based on the Black Widow Perk in Fallout 4, drawing inspiration from Porda's Sniper Pin. Print Settings: Printer Brand: Formlabs Printer: Form 1 Rafts: Yes Supports: Yes Resolution: .1mm Notes: Printed in black with supports. Due to a desire for a cleaner and flatter part, milling on the Othermill was done instead. Post-Printing Steps: Fill areas with acrylic paint. Make sure it sets overnight, regardless of any mess - you'll clean up later. Wait 8 hours to allow water to evaporate from the paint. Sand down to reveal clean borders and remove excess paint. Do a light sanding using 220 grit sandpaper. Apply a clear coat or fixativ to seal the paints, finishing with a generous layer of clear nail polish.