Black Templars Base

thingiverse

Here is a brief explanation of these three explanations: Number 1: The details are finer than 0.5mm. It didn't look so good on the Ender 3. The base is 1:1 copied from the GW base. Although these 32mm bases are called, they are actually 31.7mm in diameter. (I know I know it's unnecessary. That's just how the first try came out in FreeCAD). The base is open at the bottom. Number 2: Similar to number 1 in design, but all measurements have been increased to at least 0.5mm. This means details are slightly coarser, but may be printed better. Additionally, a plate was added to the bottom that looked funny when printing. The arm crosses also shifted slightly, I think. It couldn't be done otherwise in FreeCAD or I was too dumb. Number 3: The plate with details on the cone has not changed. The base itself (the cone) is now "cast as one" and hollow inside. The wall thickness is 0.5mm. This should give a nicer surface for the cone now.