BL Touch Mount for hypercube

thingiverse

I wanted to install a BL Touch on my printer since the proximity sensor wasn't working out for me, so I naturally chose the BL Touch. I needed to get the sensor as close as possible to the print head and the design by BS3DP didn't meet my standards (no criticism intended), so I found an alternative offered by Chavostyle. This one caught my eye, but it was off-center, so I flipped it around and printed it. As it turned out, even with the sensor fully retracted, it still obstructed the print bed, so I had to make some adjustments. So I imported the model into Fusion 360 and essentially duplicated it. I ended up with two versions, one slightly shorter than the other (1mm). I have finally uploaded the reversed version (I put this off far too long, sorry).