Bitcoin Phond Stand

prusaprinters

<p><strong>**Revised Files and Helpful Printing Data</strong>**</p><p>It's better printed on its side instead of right-side up. &nbsp;Recommend using the following perimeters for the '<strong>Bitcoin CPS Body</strong>' file:</p><ol><li>Quality: &nbsp;Standard or Higher</li><li>Wall Thickness: &nbsp;0.8</li><li>Wall Line Count: &nbsp;2</li><li>Infill Density: &nbsp;10%</li><li>Infill Pattern: &nbsp;Line</li></ol><p>If using Translucent Filaments (<i>See Pictures</i>) for the '<strong>Bitcoin CPS Body</strong>' to get a “<i>see-through</i>” look, use these perimeters:</p><ol><li>Quality: &nbsp;Standard or Higher</li><li>Wall Thickness: &nbsp;1.2</li><li>Wall Line Count: &nbsp;3</li><li>Infill Density: &nbsp;0%</li><li>Infill Pattern: &nbsp;N/A</li><li>Print Speed: &nbsp;25-35 mm/s</li></ol><p><i><strong>Only use supports (line at 5% Support fill) at the gapped space on the mounting plate, where the charging cord rises up from the bottom.</strong></i> &nbsp;While printed on its side, no supports are required on the '<strong>Bitcoin CPS Body</strong>' for the <strong>letters, logo, circle</strong>, nor the <strong>two slots at the bottom</strong> where the charging cord slides through.</p><p><i><strong>*No sanding is required for the ‘Bitcoin Letters’ if you print using the following perimeters in Cura:</strong></i></p><ol><li>&nbsp; &nbsp; &nbsp; Standard Quality or Higher</li><li>&nbsp; &nbsp; &nbsp; Wall Line Count: &nbsp;1</li><li>&nbsp; &nbsp; &nbsp; Top/Bottom Thickness: 1.0 mm</li><li>&nbsp; &nbsp; &nbsp; Infill Density: 100% (for strength when you push it in with your fingers)</li><li>&nbsp; &nbsp; &nbsp; Print Speed: &nbsp;35 mm/s</li><li>&nbsp; &nbsp; &nbsp; Wall Speed: &nbsp;20 mm/s</li></ol><p><i><strong>**Only a little sanding is needed for that notch created from the filament (FDM type) on the 'Bitcoin Circle of Logo'.</strong></i></p>