Bitcoin, Bank, Lamp

thingiverse

Bitcoin Piggy Bank Lamp. (Print B down. Use supports to your design advantage on the face. Triangles or hex give a block chain feel.) You are going to need a lamp kit. Print Bank x2. Cut lamp rod to length and glue the nut that goes inside the bank to the rod. This ensures the rod stays rigid after the socket assembly holder is put in place. Glue the two bank pieces together as you print the base and cap. When the glue is dry, install the rod with glued nut into the bank and attach the socket assembly holder. Insert a nut into the base. Thread the cord through the base, then the rod. Wire up the socket. Wrap 1 round of electrical tape around the exposed screws before placing it Safely into the socket holder. Screw the base onto the rod and enjoy! Be Cautious Of Electricity!!